Yaskawa SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL

Servo motor SGMGH type.
Rated speed: 1500r/min.
Power: 0.45kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit absolute value.
Design sequence: high precision machine tool.
Shaft end: straight shaft without key.
Optional parts: with oil seal.
High speed feed series: high speed running when no load SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL SGDV-3R5D15A002FT003
Complete separation of the main circuit and the control circuit,
Alarm can only turn off the main circuit power supply, easy to maintain.
Parameter setting device.
The parameters can be directly entered by the servo drive body.
Saving wiring.
Using a serial encoder, encoder wiring number than the original product reduced by 1/2.
Multi in one control: the use of the parameters of the switch can not use the torque, position, speed control SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL.











Sigma -v series servo unit SGDV.
Maximum applicable motor capacity: 0.4kw.
Power supply voltage: single phase AC100V.
Design sequence: A type.
Interface: MECHATROLINK- III communication command type (rotary servo motor).
Matching (hardware): paint.
Realize real time communication
With the maximum transmission speed of 100Mbps and the set of communication cycle 125S ~ 4ms, to achieve a more than 62 stations of the high speed control SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL.
Through the high speed of communication, can send and receive all kinds of control information in real time.
Contribute to cost savings
A maximum of 62 stations can be connected to the communication line, can significantly reduce wiring costs and time.
The command connector of the upper controller only needs 1,
Pulse generator for D/A converter or position instruction without speed / torque command.
High precision motion control is realized.
In addition to torque, position and speed control, but also to achieve high precision synchronization phase control.
Because the control mode can be switched on line, the complicated mechanical action can be realized more effectively and smoothly.Servo motor SGMGH type.
Rated speed: 1500r\/min.
Power: 15Kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit relative value.
Design sequence: high precision machine tool.
Shaft end: taper 1\/10, with parallel key.
Optional parts: no brake oil seal.
High speed feed series: high speed running when no load.
Complete separation of the main circuit and the control circuit,
Alarm can only turn off the main circuit power supply, easy to maaintain SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL.
Parameter setting device.
The parameters can be directly entered by the servo drive body.
Saving wiring.
Using a serial encoder, encoder wiring number tthan the original product reduced by 1\/2 SGDV-3R5D15A002FT003 MECHATROLINK-II Commands Manual SGDV-3R5D15A002FT003 USER'S MANUAL.
Multi in one control: the use of the parameters of the switch can not use the torque, position, speed control