Yaskawa SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL

Servo motor type SGMPH (speed: 3000r/min).
Power: 0.2kw.
Power supply voltage: single phase AC200V.
Serial encoder: 16 bit absolute value.
Design sequence: A.
Shaft end: straight shaft with screw.
Optional parts: no brake oil seal.
Partial flat series: the need to install the servo motor in a small space SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL.
Flexible user system SGMCS-2ZNDA31
For you to build the best system to enrich the product line to support you.
Products with single phase 200V, single phase 100V, three-phase 200V,
And for the absolute value encoder, a variety of motor with brake, belt speed reducer.
And then, because of its compliance with international standards, in the world can be assured that the use of.
Smooth running, there is a very seasonal rate of observation and control,
The speed fluctuation of the motor is greatly reduced, and the speed of the motor can be smoothly operated SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL. 。Servo motor SGMGH type.
Rated speed: 1000r\/min.
Power: 4.0kw.
Power supply voltage: three phase AC200V.
Serial encoder: 17 bit relative value.
Design sequence: B.
Shaft end: straight shaft with screw key.
Optional parts: with oil seal.
High speed feed series: high speed running when no load SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL.
Complete separation of the main circuit and the control circuit,
Alarm can only turn off the main circuit power supply, easy to maintain.
Parameter setting device.
The parameters can be directly entered by the servo drive body.
Saving wiring.
Using a serial encoder, encoder wiring number than the original product reduced by 1\/2.
Multi in one control: the use of the parameters of the switch can not use the torque, position, speed controlEquipped with INDEXER functional type servo unit (kit type).
Maximum applicable motor capacity: 5.0kw.
Power supply voltage: three phase AC200V.
Interface: instruction selection and installation (linear servo motor).
Matching (hardware): base mounting type (standard).
Matching (software): standard.
Matching (parameter): standard.
Optional module: INDEXER+ full closed loop module.
Simple.
By programming and serial programming, easy implementation of motion control.
Can also be installed through the Windows environment support tool (SigmaWin+) easy to start.
The I/O module can be connected with the upper controller simply.
Smart.
To support the operation of the main purpose of the positioning operation based on the program table.
The maximum number of programmable positioning points to 256 points.
With external poositioning, JOG speed table operation, the origin of reversion, rich features such as programmable signal output SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL.
I/O points for the input: 19 points, output: 16 points.
Speedy. SGMCS-2ZNDA31 Setup Rotational Motor Manual SGMCS-2ZNDA31 USER'S MANUAL.
High speed and high precision positioning by combining with high performance V series.
Motion control can be realized without using motion controller.